Ridge vent leaking: where the water is really coming from
A stain near the peak points at the ridge vent, but wind, frost and a starved intake cause as many leaks as the vent itself. Here is how to tell them apart from inside the attic.
A ridge vent that is leaking usually has one of four causes: wind-driven rain or snow blowing in through the slot, an exposed fastener or cap that has lifted, condensation that only looks like a leak. Or an attic that is pulling air in through the vent because the intake is blocked. Each leaves a different clue under the roof. You can read those clues without leaving the attic.
First, find out when it leaks
Timing tells you more than the stain does. Write down the weather the last three times you saw water.
- Only in a storm with strong wind? Think wind-driven rain pushed through the vent.
- After a cold snap, with frost that melts on a warm day? Think condensation.
- In any rain at all, even calm? Think a lifted cap, a bad fastener or flashing at the ridge.
Any of those answers beats guessing at a repair.
What you can check from the attic
Take a flashlight and stand at the hatch or on a safe, floored section. Look up at the underside of the deck below the ridge.
- Dark staining in a line along the peak, with clean wood lower down, often means water entering at the vent.
- Rusty nail tips with beads of frost or water point to condensation, not a hole.
- Daylight along the ridge slot is normal for a vent. Daylight in a patch, or around a pipe, is not.
- Wet insulation directly under the ridge, and nowhere else, tells you the water enters high.
Photograph what you see. A roofer will want it.
Wind-driven rain is the common one
A ridge vent is an open slot by design. Many are built with an internal baffle or filter to hold back blown rain. But a heavy gust can still push water through, especially on a low slope or a vent installed with the wrong cap shingles. If the stain appears only in the worst storms, the vent may be doing exactly what it was built to do. And the question becomes whether that amount of water matters.
A starved intake can make it worse
Here is a cause most people miss. When soffit intake is blocked, the attic pulls replacement air in through the ridge instead, and that draws rain with it. Check that the eaves are clear. Soffit vents, the intake nobody checks and attic baffles cover how insulation ends up choking them. A ridge vent with no intake under it is only a hole, as intake and exhaust explains.
Condensation fools almost everyone
In winter, warm indoor air reaches the cold underside of the deck and drips. It looks like a leak at the peak because that is the coldest, highest spot. Fixing the vent will change nothing. The cure is air sealing and balanced ventilation. See attic condensation for the signs.
Why we stop at the attic floor
Checking the vent itself means walking the ridge, the steepest and most exposed part of the roof, and lifting caps or resealing fasteners. This blog gives no steps for that, and we say so on purpose. Falls from roofs are a leading cause of serious injury in the trade. Read working at height safely.
When to call a pro
- Water enters in ordinary rain, not only in storms.
- You can see daylight or a stain that spreads each time it rains.
- Insulation under the ridge stays wet for days.
- The vent cap looks lifted, cracked or missing from the ground with binoculars.
Ask a licensed roofer to inspect the ridge and say in writing what they found. A good one will check the intake first. Be wary of anyone who proposes a new roof before looking inside the attic. How much ventilation you need helps you judge their answer.
Frequently asked questions
Why is my ridge vent leaking?
The usual causes are wind-driven rain pushed through the slot, a lifted cap or exposed fastener, condensation that looks like a leak, or a blocked intake that pulls air and water in through the ridge.
Can a ridge vent leak in heavy rain even if installed correctly?
Yes. A ridge vent is an open slot, and strong wind can blow rain past its baffle or filter. Water only in the worst storms can be normal behavior.
How do I tell a leak from condensation at the ridge?
Condensation appears in cold weather as frost or drops on nail tips and the deck underside, with no relation to rain. A leak follows rain and stains in a line or patch.
Can I seal a ridge vent myself?
Not safely. It means working on the ridge, the most exposed part of the roof. Observe from the attic and hire a licensed roofer.
Does a blocked soffit make a ridge vent leak?
It can. With no intake at the eaves, the attic draws air in through the ridge and may pull blown rain in with it.
Sources
What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.
- US EPA. Improving Indoor Air Quality
- US EPA. Introduction to Indoor Air Quality